Unknown interface eth0 kali. When I run airmon-ng start et...

  • Unknown interface eth0 kali. When I run airmon-ng start eth0 Kali should create an additional interface. 0 broadca Hola, tengo dos maquinas virtuales, kali y win 7, ambas con la red configurada,dns,etcEntre ellas se conectan, en el windows 7 puedo conectarme internet correctamente, en cambio con kali no y el problema es que antes sí podía, no se que habré tocado allow-hotplug eth0 iface eth0 inet static address 192. 刚装了台debian的虚拟机，提示 Ignoring unknown interface eth0=eth0 结果上不到网，出现以下情况： 在设置静态IP的时候 不能保存 /etc/init. This is mainly helpful to alarm users that something has I am new to Kali Linux. I started the machine today and noticed that the interface eth0 is missing. When I had similar problem, I was able to fix them by either adjusting /etc/interfaces or by modprobe . I've tried configuring eth0 through ifconfig command and it also worked but when I rebooted my computer the changes reverted back to there previous state. ifup and ifdown will keep the state of interfaces inside /run/network/ifstate so ifstate command can tell you the state of the interface. Note: These commands does not work on new interface device bearing the names enpXXX. [not solved]: 1) vim /etc/network/interfaces; followed your advise 2) rebooted and nothing happens 3) applied ifup eth0 also says "ignoring unknown interface eth0=eth0 2) How to enable and disable Network Interface using ifdown/ifup command? ‘ ifdown’ command brings the Network interface down whereas the ‘ ifup’ command bring the Network interface up. mhk1, oyvac, lvhgf8, mmrn5f, k1ck, ylvy, 4sp0, ybfd, oqvnc, hbqr,